Trinity RGH | Can't boot into Xell | Flashing Red Light on Glitch

Hello,

I was finally able to read my nand. It had two bad blocks. All good, JRunner remapped it.

I created the ECC image and wrote it to the NAND. Although I did get this error:

Version: 10
Flash Config: 0x00023010
Writing Nand
image_00000000.ecc
Error: 601 writing block 17
Error: 601 writing block 18
Done!
in 0:19 minec

When I plug in my console to power and hdmi to try and boot into xell, something strange happens.

I put the RF board on, and am using my controller to turn it on....

Trinity RGH | Can't boot into Xell | Flashing Red Light on Glitch