Hi,
While installing the QSBs I lifted 3 of the HANA resistors (r4b25, r4b24 and r4b6). I repaired them by using a combination of soldering to the traces and using alternative points on the back of the board. Everything seems to be properly connected (checked with a multimeter).
I get RROD 0010.
When reading the point close to the HANA chip for R4B6 it has continuity with GND. Is it meant to be a grounding point?
I had a bridged point on the nand-x QSB at one point - smoke and all....
CR4 install RROD
While installing the QSBs I lifted 3 of the HANA resistors (r4b25, r4b24 and r4b6). I repaired them by using a combination of soldering to the traces and using alternative points on the back of the board. Everything seems to be properly connected (checked with a multimeter).
I get RROD 0010.
When reading the point close to the HANA chip for R4B6 it has continuity with GND. Is it meant to be a grounding point?
I had a bridged point on the nand-x QSB at one point - smoke and all....
CR4 install RROD