Error after burning with Sony Optiarch

I recently purchased a Sony Optiarch 5280s-CB-Plus drive to burn XGD3 backup disks. I am using Verbatim DL Disks. I use the default settings on Img Burn (which is the settings I most commonly seen while researching) and I have no problems during the burn. Afterward, I put the burned game into my xbox and it will load up and act like it is going to work, though it will then give me an error that says "This disk is not supported." Is there settings I should do differently on Img Burn, or is this...

Error after burning with Sony Optiarch